TOWER CAM PG2
Supplier item link
PG2 PIR Outdoor TOWER CAM
Item no. 119883 · Teletec
3,007.80 NOK · VAT basis not confirmed
Open 119883 at Teletec ↗Troubleshooting – step by step
Motion · PG2 / PowerG · Wireless link to panel
PowerG alone does not establish compatibility with your PM10 or IQ Panel. Check the exact model, frequency, panel and software.
Guides and documents
- Installation Guide English - TOWER CAM PG2 Installation Guide - Original Software Version
- Data Sheet English - Tower CAM Data Sheet
- Brochure English - Tower Family Brochure
- Video English - Visonic Product Highlight Video
A Norwegian step-by-step customer guide and dedicated troubleshooting video are not yet documented for this model. Use the model manual for opening and battery type.
Supply chain and compatibility
Help when the product does not work
Choose the symptom and check the model scope before following the steps. This is troubleshooting, not a list of confirmed product defects.
PowerMaster shows NOT READY
Applies to: PowerMaster-10 G2. PG2 accessories only when fitted to this panel; not PowerG+ or IQ Panel.
- Read the display and review open zones/faults as described in the user guide. Record the zone, room and full message.
- For an open door or window message, close it fully. Look to see whether the magnet and sensor are still in place.
- Check the display again. Battery, tamper or communication faults require the named sensor manual. Do not replace the panel battery because of a sensor fault.
- When the panel is ready, use normal arming. Do not bypass an unknown zone or force arm to remove the warning.
Check the result: The panel shows READY with no unresolved fault and normal control works.
Stop and get help: If the zone remains open or the fault concerns communication/tamper, contact support with the zone and sensor model.