Enable the alarm when you go
← More tasks for the same user
Before you start: Have access to the correct system and area. Use your personal account.
Do not bypass a sensor simply to arm; follow the system's agreed procedure.
iPhone: design can vary with iOS and SmartHomeSec version. The steps below describe documented features.
Steps
- Close the doors and windows that should be protected. Open Security and select the correct area.
- Select Arm and enter your personal alarm code if requested.
- Read any open-zone or fault messages. Establish the cause before continuing.
- Follow the system's agreed exit delay and confirm that the area finally shows Armed.
You should see this: The correct area is confirmed armed.
If it does not work
- If a menu or feature is missing, check your role, area and the task's source status.
- If the expected result does not appear, note the error, device and time. Contact the installer or responsible administrator.
Updated screenshot for this task: missing.
Source Base and Date
The guide is compiled from the sources below. Menu selection from older PDFs is not confirmed in today's edition.
- SmartHomeSec User’s Guide – Vesta, kopi hos BNT — Date not specified; older app interface
Reviewed 08.09.2026. Control against demo plants: not performed.
Something not working?
Choose the symptom. Always check the model and connection before following a procedure.
Images, videos and sources
A product/guide image is missing on this page.
No direct troubleshooting video is registered on this page. A general manual is not labelled a troubleshooting video.