Connect a sensor event to a PIRCAM image
← More tasks for the same user
Before you start: Have assigned installer access, the correct panel model and the installation plan. Agree changes and test events with the responsible person.
Check availability and the exact menu against the panel and version. Test according to the agreed service procedure.
Steps
- Open the configuration of the sensor that should trigger the image.
- Select the PIRCAM to associate with it. The source says the rule is created automatically.
- Perform an agreed test event and check that the image appears in the event log.
You should see this: The correct sensor event produces an image from the correct PIRCAM.
If it does not work
- If a menu or feature is missing, check your role, area and the task's source status.
- If the expected result does not appear, note the error, device and time. Contact the installer or responsible administrator.
Updated screenshot for this task: missing.
Source Base and Date
The guide is compiled from the sources below. Menu selection from older PDFs is not confirmed in today's edition.
- Vesta: FW 35D and changes in the interface — 18.03.2026 · oppdatert 20.05.2026
Reviewed 08.09.2026. Control against demo plants: not performed.
Something not working?
Choose the symptom. Always check the model and connection before following a procedure.
Images, videos and sources
A product/guide image is missing on this page.
No direct troubleshooting video is registered on this page. A general manual is not labelled a troubleshooting video.