Check devices and configuration
← More tasks for the same user
Before you start: Have assigned installer access, the correct panel model and the installation plan. Agree changes and test events with the responsible person.
Steps
- Select the correct system and open Settings with assigned installer access.
- Open Device. The older manual uses Add device to add a device.
- Compare device ID, area and zone name with the physical equipment.
- Open the device settings and compare response and delay with the installation plan.
- After an approved change, test the function and record before and after in the service documentation.
You should see this: The configuration matches the installation and has been functionally tested.
If it does not work
- No device found: check the model's enrolment procedure and communication.
- Incorrect device ID or zone: stop and compare with the installation plan before saving.
Older screenshots – only show as reference
This is not the documentation of today's menu location.
Updated screenshot for this task: missing.
Source Base and Date
The guide is compiled from the sources below. Menu selection from older PDFs is not confirmed in today's edition.
- Vesta Installation Manual – originalmanual hos GI Security — Date not specified; older web portal
- Vesta GitBook: panelinstallasjon — Running GitBook; version date not confirmed
Reviewed 08.09.2026. Control against demo plants: not performed.
Something not working?
Choose the symptom. Always check the model and connection before following a procedure.
Images, videos and sources
Images or figures are present on this page. Check the caption for model and version.
No direct troubleshooting video is registered on this page. A general manual is not labelled a troubleshooting video.